The factors that cause the uneven filling of the filling machine are related to the air pressure. In addition, the hand is too close to the filling mouth during the filling process, which is blocked, or there is a problem with the numerical setting of the filling machine system, which causes the uneven filling. You can learn about the Jiangmen filling machine, which sets the weight and automatically weighs the weight, with the tolerance controlled at 0.1g

Both the filling machine and manual filling are unlikely to be filled evenly, so further beating is required to ensure that the filling is evenly distributed. I haven't seen anything that is filled with velvet but not brushed.

Compared with manual filling, machine filling is fast, efficient, accurate in weighing, less in loss, and saves expensive labor costs and space.

The pile of the filling machine should be evenly laid, and the pile should be loosened and not lumped together

The cut piece is impermeable, and the filled pile is returned by air pressure, resulting in unevenness. How to solve this problem

The automatic filling machine is very uniform according to the principle. There are several reasons for this problem:

1. The air pressure is unstable. This problem does not refer to the output air pressure of the air compressor, but the control air pressure inside the machine. It may be a problem with a control valve.

2. The filling machine itself has no air return system, and the cut pieces are not breathable. The filled pile is returned by the air pressure, resulting in uneven.

3. When cutting pieces, my hand blocked the lint outlet, resulting in more pieces being cut and less pieces being cut.

4. There is a problem with the automatic down system, causing too much or too little down in the down box.

Article source: Jiangmen filling machine http://www.jm-weishi.com/