In recent years, with the rapid development of social economy and the rapid change of science and technology, many new things begin to appear around us, and the filling machine is more and more widely used in our daily life. However, when we use the down filling machine, the phenomenon of down jacket leakage often occurs. So how should we try to avoid the leakage of down jackets? Here are some ways to avoidJiangmen filling machineCommon methods for down coat leakage:

1. The fabric should be dense enough, at least 410T or more, with half of the warp and weft density, and the back should be calendered;

2. Use a round mouth needle of No. 7-9. Generally, change the needle every 3 hours. Don't wait for the needle to become dull;

3. Don't drive too fast, or the needle will heat up and melt the fabric, and the pinhole will not shrink;

4. Professional Pengsong thread will naturally block the pinhole, instead of ordinary polyester thread;

5. The flying silk inside the down is easy to penetrate the fabric, so the content of flying silk inside the down should not be too high;

6. Craft structure, at least two lines shall be set on the side seam, otherwise the down will leak out from the side seam, especially the side seam near the shoulder and pocket, which is easy to cut corners;

7. Quilting shall be carried out before filling, and the air pressure of machine filling shall not be too high;

8. The template used for quilting shall not be too thick, and it is recommended that it should not exceed 2MM;

The above points are common suggestions to avoid down leakage of down jackets, so we must pay attention to the above points when using the down filling machine.

文章源自 Jiangmen filling machine http://www.jm-weishi.com